Mike> However, I can't get it going using pilot-xfer (0.9.5-pre5), or
Mike> more importantly, malsync (2.0.6).
>>> "Greg" == Greg KH <[EMAIL PROTECTED]>
Greg> What kernel are you using?
v2.4.4 (binary downloaded from Debian "testing" distribution)
Greg> Are you using the usb-uhci.o host controller driver instead of the
Greg> uhci.o host controller driver
Yup, usb-uhci is loaded, though lsmod reports it as unused right now:
visor 8240 0
usbserial 17424 0 [visor]
usb-uhci 21968 0 (unused)
usbcore 48176 1 [visor usbserial usb-uhci]
Greg> Any kernel debug logs with debugging for the visor driver
Greg> available?
Here's what gets generated when I try running malsync from
/etc/hotplug/usb/visor ...
| hub.c: USB new device connect on bus1/2, assigned device number 40
| usbserial.c: Handspring Visor converter detected
| visor.c: Handspring Visor: Number of ports: 2
| visor.c: Handspring Visor: port 1, is for Generic use and is bound to ttyUSB0
| visor.c: Handspring Visor: port 2, is for HotSync use and is bound to ttyUSB1
| usbserial.c: Handspring Visor converter now attached to ttyUSB0 (or usb/tts/0 for
devfs)
| usbserial.c: Handspring Visor converter now attached to ttyUSB1 (or usb/tts/1 for
devfs)
| usb.c: USB disconnect on device 40
| usbserial.c: Handspring Visor converter now disconnected from ttyUSB0
| usbserial.c: Handspring Visor converter now disconnected from ttyUSB1
--
Mike
_______________________________________________
Pilot-unix mailing list
[EMAIL PROTECTED]
http://hcirisc.cs.binghamton.edu/mailman/listinfo/pilot-unix
