Larry Bullis wrote an article on how to make accurate holes using a set of
feeler gauges and a pin vise (Reprinted from: Pinhole Journal Vol.3*2,
August 1987, page 32):
http://www.p at ???????/resources/articles/poke.html
or a PDF version at:
ftp://ftp.p at ???????/poke_doc.pdf
- Gregg
At 08:48 AM 2/10/01 -0600, you wrote:
It's more difficult to measure the hole than the boring tool, which is
easy with a vernier caliper that goes to .001" or so. What I've done
is measure and mark (with tape so it's easy to stop at the right
diameter) small sewing needles.
Pam
_________________________________________
Pinhole Visions at http://www.p at ???????
