[EMAIL PROTECTED] wrote: > Witam :) > Po raz pierwszy instaluje karte wifi i mam taki problem . Zainstalowalem ja > ndiswrapperem (wg. opisu w dokumentacji pld) i wszystko poszlo ok tylko ze > teraz przy starci mam > > Podnoszenie interfejsu wlan0 > hostname: Odnalezienie nazwy urzadzenia jest niemozliwe > Error for wireless request "Set Nickname" (8B1C): > too few arguments > > podjerzewam ze zapomnialem skonfigurowac jakiegos pliku, tylko jakiego ? i > jak? > > Pod spodem wkleje niektore komunikaty ktore mysle ze moga zawierac przydatne > informacje ;) > > lspci > [...] > 00:0e.0 Network controller: Texas Instruments ACX 111 54Mbps Wireless > Interface > [...] > > dmesg > [...] > ACPI: PCI Interrupt 0000:00:0d.0[A] -> Link [LNKB] -> GSI 11 (level, low) -> > IRQQ > 11 > ndiswrapper version 1.2 loaded (preempt=no,smp=no) > ndiswrapper: driver tnet1130 (OEM,12/02/2003,5.0.20) loaded > ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 10 > PCI: setting IRQ 10 as level-triggered > ACPI: PCI Interrupt 0000:00:0e.0[A] -> Link [LNKC] -> GSI 10 (level, low) -> > IRQQ > 10 > ndiswrapper: using irq 10 > wlan0: ndiswrapper ethernet device 00:40:f4:ad:c2:da using driver tnet1130, > conff > iguration file 104C:9066.5.conf > wlan0: encryption modes supported: WEP > [...] > > ndiswrapper -l > [...] > Installed ndis drivers: > tnet1130 driver present, hardware present > [...] > > ifcfg-wlan0 > DEVICE="wlan0" > IPADDR="192.10.10.45/24" > ONBOOT="yes" > BOOTPROTO="none
moze dodac cos takiego do ifcfg=wlan0: WLAN_MODE=Managed WLAN_ESSID=siec WLAN_KEY="s:haslo" " > _______________________________________________ > pld-users-pl mailing list > [email protected] > http://lists.pld-linux.org/mailman/listinfo/pld-users-pl _______________________________________________ pld-users-pl mailing list [email protected] http://lists.pld-linux.org/mailman/listinfo/pld-users-pl
