okej, znalazłem na dysku 3 dmesg jeden jest pusty, drugi jest wykonywalny, a w trzecim jest to:
Linux version 2.6.14.7-2 ([EMAIL PROTECTED]) (gcc version 3.3.6 (PLD Linux)) #1 Mon Feb 6 08:37:07 UTC 2006 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000001fff0000 (usable) BIOS-e820: 000000001fff0000 - 000000001fff3000 (ACPI NVS) BIOS-e820: 000000001fff3000 - 0000000020000000 (ACPI data) BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved) 0MB HIGHMEM available. 511MB LOWMEM available. On node 0 totalpages: 131056 DMA zone: 4096 pages, LIFO batch:1 Normal zone: 126960 pages, LIFO batch:31 HighMem zone: 0 pages, LIFO batch:1 DMI 2.3 present. ACPI: RSDP (v000 VT8363 ) @ 0x000f7ef0 ACPI: RSDT (v001 VT8363 AWRDACPI 0x42302e31 AWRD 0x00000000) @ 0x1fff3000 ACPI: FADT (v001 VT8363 AWRDACPI 0x42302e31 AWRD 0x00000000) @ 0x1fff3040 ACPI: DSDT (v001 VT8363 AWRDACPI 0x00001000 MSFT 0x0100000c) @ 0x00000000 ACPI: PM-Timer IO Port: 0x4008 Allocating PCI resources starting at 30000000 (gap: 20000000:dfff0000) Built 1 zonelists Kernel command line: BOOT_IMAGE=pld ro root=341 Local APIC disabled by BIOS -- you can enable it with "lapic" mapped APIC to ffffd000 (01402000) Initializing CPU#0 PID hash table entries: 2048 (order: 11, 32768 bytes) Detected 851.675 MHz processor. Using pmtmr for high-res timesource Console: colour VGA+ 80x25 Dentry cache hash table entries: 131072 (order: 7, 524288 bytes) Inode-cache hash table entries: 65536 (order: 6, 262144 bytes) Memory: 515308k/524224k available (1861k kernel code, 8368k reserved, 473k data, 216k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay using timer specific routine.. 1704.97 BogoMIPS (lpj=3409954) Security Framework v1.0.0 initialized SELinux: Initializing. SELinux: Starting in permissive mode Mount-cache hash table entries: 512 CPU: After generic identify, caps: 0183f9ff c1c7f9ff 00000000 00000000 00000000 00000000 00000000 CPU: After vendor identify, caps: 0183f9ff c1c7f9ff 00000000 00000000 00000000 00000000 00000000 CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line) CPU: L2 Cache: 64K (64 bytes/line) CPU: After all inits, caps: 0183f9ff c1c7f9ff 00000000 00000020 00000000 00000000 00000000 Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. mtrr: v2.0 (20020519) CPU: AMD Duron(tm) Processor stepping 01 Enabling fast FPU save and restore... done. Checking 'hlt' instruction... OK. checking if image is initramfs...it isn't (no cpio magic); looks like an initrd Freeing initrd memory: 245k freed ACPI: Looking for DSDT in initramfs... error, could not open file /DSDT.aml. ACPI: setting ELCR to 0800 (from 0e20) NET: Registered protocol family 16 ACPI: bus type pci registered PCI: PCI BIOS revision 2.10 entry at 0xfb3a0, last bus=1 PCI: Using configuration type 1 ACPI: Subsystem revision 20050902 ACPI: Interpreter enabled ACPI: Using PIC for interrupt routing ACPI: PCI Root Bridge [PCI0] (0000:00) PCI: Probing PCI hardware (bus 00) ACPI: Assume root bridge [\_SB_.PCI0] bus is 0 PCI quirk: region 6000-607f claimed by vt82c868 HW-mon PCI quirk: region 5000-500f claimed by vt82c868 SMB Boot video device is 0000:01:00.0 ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT] ACPI: PCI Interrupt Link [LNKA] (IRQs 1 3 4 5 6 7 10 *11 12 14 15) ACPI: PCI Interrupt Link [LNKB] (IRQs 1 3 4 5 6 7 10 11 12 14 15) *9 ACPI: PCI Interrupt Link [LNKC] (IRQs 1 3 4 *5 6 7 10 11 12 14 15) ACPI: PCI Interrupt Link [LNKD] (IRQs 1 3 4 5 6 7 *10 11 12 14 15) Linux Plug and Play Support v0.97 (c) Adam Belay pnp: PnP ACPI init pnp: PnP ACPI: found 12 devices PnPBIOS: Disabled by ACPI PNP PCI: Using ACPI for IRQ routing PCI: If a device doesn't work, try "pci=routeirq". If it helps, post a report TC classifier action (bugs to [email protected] cc [EMAIL PROTECTED]) PCI: Bridge: 0000:00:01.0 IO window: disabled. MEM window: dc000000-ddffffff PREFETCH window: d0000000-d7ffffff PCI: Setting latency timer of device 0000:00:01.0 to 64 Machine check exception polling timer started. audit: initializing netlink socket (disabled) audit(1139844520.172:1): initialized Total HugeTLB memory allocated, 0 VFS: Disk quotas dquot_6.5.1 Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) SELinux: Registering netfilter hooks Initializing Cryptographic API Applying VIA southbridge workaround. PCI: Disabling Via external APIC routing Real Time Clock Driver v1.12 isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found PNP: PS/2 Controller [PNP0303:PS2K,PNP0f13:PS2M] at 0x60,0x64 irq 1,12 serio: i8042 AUX port at 0x60,0x64 irq 12 serio: i8042 KBD port at 0x60,0x64 irq 1 Serial: 8250/16550 driver $Revision: 1.90 $ 8 ports, IRQ sharing enabled ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A io scheduler noop registered io scheduler anticipatory registered io scheduler deadline registered io scheduler cfq registered RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize mice: PS/2 mouse device common for all mice NET: Registered protocol family 2 input: AT Translated Set 2 keyboard on isa0060/serio0 IP route cache hash table entries: 8192 (order: 3, 32768 bytes) TCP established hash table entries: 32768 (order: 5, 131072 bytes) TCP bind hash table entries: 32768 (order: 5, 131072 bytes) TCP: Hash tables configured (established 32768 bind 32768) TCP reno registered TCP bic registered NET: Registered protocol family 1 NET: Registered protocol family 17 Using IPI Shortcut mode ACPI wakeup devices: SLPB PCI0 USB0 USB1 MODM UAR1 UAR2 ECP1 ACPI: (supports S0 S1 S4 S5) RAMDISK: Compressed image found at block 0 VFS: Mounted root (romfs filesystem) readonly. Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx VP_IDE: IDE controller at PCI slot 0000:00:07.1 PCI: Via IRQ fixup for 0000:00:07.1, from 255 to 0 VP_IDE: chipset revision 6 VP_IDE: not 100% native mode: will probe irqs later VP_IDE: VIA vt82c686b (rev 40) IDE UDMA100 controller on pci0000:00:07.1 ide0: BM-DMA at 0xd000-0xd007, BIOS settings: hda:DMA, hdb:DMA ide1: BM-DMA at 0xd008-0xd00f, BIOS settings: hdc:DMA, hdd:DMA Probing IDE interface ide0... hda: WDC WD800JB-00JJC0, ATA DISK drive hdb: ST330621A, ATA DISK drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 Probing IDE interface ide1... hdc: _NEC DVD_RW ND-3540A, ATAPI CD/DVD-ROM drive hdd: CD-W54E, ATAPI CD/DVD-ROM drive ide1 at 0x170-0x177,0x376 on irq 15 hda: max request size: 128KiB hda: 156301488 sectors (80026 MB) w/8192KiB Cache, CHS=65535/16/63, UDMA(100) hda: cache flushes supported hda: hda1 hda2 < hda5 hda6 > hdb: max request size: 128KiB hdb: 58633344 sectors (30020 MB) w/512KiB Cache, CHS=58168/16/63, UDMA(100) hdb: cache flushes not supported hdb: hdb1 hdb2 hdb3 VFS: Mounted root (ext2 filesystem) readonly. Trying to move old root to /initrd ... okay Freeing unused kernel memory: 216k freed Adding 1020116k swap on /dev/hdb2. Priority:-1 extents:1 across:1020116k usbcore: registered new driver usbfs usbcore: registered new driver hub ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI) ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 11 PCI: setting IRQ 11 as level-triggered ACPI: PCI Interrupt 0000:00:09.0[A] -> Link [LNKA] -> GSI 11 (level, low) -> IRQ 11 ohci_hcd 0000:00:09.0: OHCI Host Controller ohci_hcd 0000:00:09.0: new USB bus registered, assigned bus number 1 ohci_hcd 0000:00:09.0: irq 11, io mem 0xdf001000 hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected usbcore: registered new driver usbmouse drivers/usb/input/usbmouse.c: v1.6:USB HID Boot Protocol mouse driver Linux agpgart interface v0.101 (c) Dave Jones agpgart: Detected VIA Twister-K/KT133x/KM133 chipset agpgart: AGP aperture is 64M @ 0xd8000000 input: ImExPS/2 Generic Explorer Mouse on isa0060/serio1 macie jakiś pomysł? _______________________________________________ pld-users-pl mailing list [email protected] http://lists.pld-linux.org/mailman/listinfo/pld-users-pl
