On Monday 06 of August 2007, Rafał xxx wrote: > Witam > > Próbuję ustawić swoją radiówkę ( Intel(R) PRO/Wireless 3945ABG Network > Connection ), tak aby łączyła się z siecią, ale nie może mi to jakoś > wyjsc, mógłby może ktos pomóc? > Robie to wg schematu który znalazłem za pomocą google :) > > [EMAIL PROTECTED] ~]$ sudo rmmod ipw3945 > [EMAIL PROTECTED] ~]$ sudo modprobe ipw3945 > [EMAIL PROTECTED] ~]$ sudo /sbin/ipw3945d > ipw3945d - regulatory daemon > Copyright (C) 2005-2006 Intel Corporation. All rights reserved. > version: 1.7.22 > Intel PRO/Wireless 3945ABG Network Connection found at: > /sys/bus/pci/drivers/ipw3945/0000:04:00.0 > Daemon launched as pid 3360. Exiting. > [EMAIL PROTECTED] ~]$ sudo ifconfig eth1 up > [EMAIL PROTECTED] ~]$ sudo iwconfig eth1 essid default > [EMAIL PROTECTED] ~]$ sudo iwconfig > lo no wireless extensions. > > eth0 no wireless extensions. > > eth1 IEEE 802.11g ESSID:"default" > Mode:Managed Frequency:2.437 GHz Access Point: > 00:13:46:A6:9F:8E Bit Rate:54 Mb/s Tx-Power:15 dBm > Retry limit:15 RTS thr:off Fragment thr:off > Encryption key:off > Power Management:off > Link Quality=80/100 Signal level=-52 dBm Noise level=-53 dBm > Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 > Tx excessive retries:0 Invalid misc:1 Missed beacon:0 > A uruchom w tym momencie na drugiej sesji tcpdump -v -n -i eth1
> [EMAIL PROTECTED] ~]$ sudo dhcpcd eth1 > [EMAIL PROTECTED] ~]$ sudo ping 192.168.1.1 > PING 192.168.1.1 (192.168.1.1) 56(84) bytes of data. > From 192.168.1.7 icmp_seq=1 Destination Host Unreachable A co pokazuje route -n -- Mateusz Korniak _______________________________________________ pld-users-pl mailing list [email protected] http://lists.pld-linux.org/mailman/listinfo/pld-users-pl
