9/9/2008, "Sylwester Gruszka" <[EMAIL PROTECTED]> napisał/a:
>Witam, > >Kiedy ustawię w biosie tryb pracy magistrali sata na AHCI (jeszcze jest do >wyboru RAID i Native IDE) to nie chce mi sie włączać GRUB: >---------------------- >GRUB Loading stage 1.5. > >GRUB Loading, please wait... >Error 18 >---------------------- >i stoi :/ >Kiedy ustawię tryb sata na IDE to działa ale mimo wszystko wolałbym to AHCI... >Jakieś powiedzi? na ktorym GB dysku zaczyna ci sie partycja z kernelem? <doc> error 18 : Selected cylinder exceeds maximum supported by BIOS. This error is returned when a read is attempted at a linear block address beyond the end of the BIOS translated area. This generally happens if your disk is larger than the BIOS can handle (512MB for (E)IDE disks on older machines or larger than 8GB in general). </doc> ztcp to limitem gruba jest 1023 cylinder, co przy mapowaniu biosu 255 glowic, 63 sektory na sciezke daje gorna granice na poziomie 255*63*1023*512=8'414'461'440 bajtow. u mnie grub laduje kernel na ahci bez problemu, ale partycja /dev/sda2 zaczyna sie ponizej 1024 cylindra. Disk /dev/sda: 164.6 GB, 164696555520 bytes 255 heads, 63 sectors/track, 20023 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes Disk identifier: 0x0f800000 Device Boot Start End Blocks Id System /dev/sda1 * 1 747 6000246 82 Linux swap /dev/sda2 748 2206 11719417+ 83 Linux /dev/sda3 2207 15093 103514827+ 83 Linux /dev/sda4 15094 20023 39600225 83 Linux _______________________________________________ pld-users-pl mailing list [email protected] http://lists.pld-linux.org/mailman/listinfo/pld-users-pl
