First of all, I want to tell you that my jaw dropped to the floor when I
ran Plex86 the first time. Seeing that familiar DOS boot screen was just
incredible. I've figured out how to partition and format the "drive" and
I've even attempted to install Windows on it. After playing with it, I
have some questions.
1) Can I allocate any more than 32MB of RAM to Plex86?
2) Can Plex86 boot from the HD image created, rather than a floppy disk?
Do you simply specify the HD image as the boot image as well?
3) Is there a way to get Plex86 to boot an existing installation of
Windows on another physical drive?
I used the FreeDOS boot image to partition and format the "drive" then
used a Win98 boot disk to enable CD-ROM support and ran setup from a
WinME CD. It runs scandisk fine, but seems to hang at the finished w/
scandisk screen.
4) How do I install a Windows envorinment for Plex86 to run if not from
a Win CD?
5) I tried a trial of VMware and when attempting to install WinME it
said that it could be ne installed because my processor was under 150
mhz. Will I run into this problem?
6) What Windows environment would you recommend I use?
7) What performance tweaks can you recommend to get the VM to run any
faster?
Thanks so much in advance!
