Good morning
A few weeks ago I activated ftp for a standalone Plone server (not zeo).
Therefore I added the following to the buildouot.cfg section "[instance]":
[instance]
zope-conf-additional =
<ftp-server>
address = 2121
</ftp-server>
I found the hint on a usergroup, that I could use the "old" settings from
zope.conf in the buildout.cfg within the Instance-Section! So: I haven't tested
it, but assigning this "logic" to the activation of webdav it should work if
you add this to your buildout.cfg "[instance]"-section:
[instance]
zope-conf-additional =
<webdav-source-server>
address = 1980
</webdav-source-server>
Regards
Viktor
> -----Ursprüngliche Nachricht-----
> Von: Chris Duan [mailto:[email protected]]
> Gesendet: Donnerstag, 17. November 2011 09:05
> An: [email protected]
> Betreff: Re: [Setup] How to enable WebDav on Plone 4.1.2 zeo model
>
> Thank you for your reply.
>
> I have tried as you said. But is was still not working.
>
> This time ,I added
>
> "
> [instance]
> webdav-address = 8122
> "
>
> before [versions]，Then re-build，The error message is still there
>
> "Unused options for buildout: 'webdav-address'."
>
> I had also tried [client1][instance1]……
>
> --
> View this message in context: http://plone.293351.n2.nabble.com/How-to-
> enable-WebDav-on-Plone-4-1-2-zeo-model-tp7002612p7003138.html
> Sent from the Installation, Setup, Upgrades mailing list archive at
> Nabble.com.
> _______________________________________________
> Setup mailing list
> [email protected]
> https://lists.plone.org/mailman/listinfo/plone-setup
_______________________________________________
Setup mailing list
[email protected]
https://lists.plone.org/mailman/listinfo/plone-setup
