In the end I was able to get it up and running but through a bit of a hack.
The binary installer unpacked and created the initial buildout.cfg in the zinstance subfolder. I had to manually go in and run ./bin/buildout though (and not sure if i had to manually install the artifact it was trying to download). This got me up and running (found here: http://blog.redturtle.it/redturtle-blog/install-plone-4-on-osx-from-scratch) but I'm not sure why the installer thinks I am offline. That is definitely not the case nor could I figure out how to make it not think of that. Thanks, -Rob. On Mon, Apr 30, 2012 at 8:01 AM, Steve McMahon <[email protected]> wrote: > On Mon, Apr 30, 2012 at 6:41 AM, Héctor Velarde > <[email protected]>wrote: > >> On 26/04/12 15:32, rob.shin wrote: >> >>> Error: Couldn't download 'ftp://xmlsoft.org/libxml2/** >>> libxml2-2.7.8.tar.gz <ftp://xmlsoft.org/libxml2/libxml2-2.7.8.tar.gz>' >>> in >>> offline mode. >>> >> >> are you connected to the internet? > > > That should not be necessary when using one of our installers. And, when > using a binary installer, it won't help since the produced installation > doesn't have the ability to build new binary components. > > _______________________________________________ > Setup mailing list > [email protected] > https://lists.plone.org/mailman/listinfo/plone-setup > >
_______________________________________________ Setup mailing list [email protected] https://lists.plone.org/mailman/listinfo/plone-setup
