I've installed the blackmagic drivers on my machine (kubuntu 18.04) that
is using the exact same kernel successfully, and without problems....
Perhaps the driver is failing the DKMS driver compilation because you
are missing the kernel headers.
Try doing:
sudo apt install linux-headers-generic
That should allow the drivers to compile successfully.
Hope that helps,
Brian
On 09/08/2018 01:03 PM, Matthew Gibson wrote:
so, As I have been working on this problem. There are no snaps for the
specified software: desktopvideo, desktopvideo-gui, mediaexpress.
While attempting to install them via the deb, I get dependency
problems revolving around dkms. While attempting an 'apt --fix-broken
install' I get this output: https://pastebin.com/AtwWb8UR (note: paste
will be up only 1 week from this email send date)
So at this time All I want is to be able to use the capture device
with OBS. I imagine I am attempting to go the long way to get to where
I want to be.
lspci -vv outputs: 02:00.0 Multimedia video controller: Blackmagic
Design Intensity Pro
Subsystem: Blackmagic Design Intensity Pro
Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Interrupt: pin A routed to IRQ 255
Region 0: Memory at f7c00000 (32-bit, non-prefetchable) [disabled]
[size=1M]
Region 1: Memory at f7b00000 (64-bit, non-prefetchable) [disabled]
[size=1M]
Capabilities: <access denied>
I'm going to start poking around for how to build a kernel module to
enable the blackmagic design card
On Fri, Sep 7, 2018 at 10:43 AM Matthew Gibson
<[email protected] <mailto:[email protected]>>
wrote:
None that I observed or detected. I will be working on it again
tomorrow morning.
On Fri, Sep 7, 2018, 9:55 AM Brian Cluff <[email protected]
<mailto:[email protected]>> wrote:
On 09/05/2018 01:34 PM, Matthew Gibson wrote:
> The software debs I found at the blackmagic website will
start to be
> installed through ubuntus software management application,
but no joy
> as far as a runnable package.
Did you get errors while installing? If so, what were they?
Brian
---------------------------------------------------
PLUG-discuss mailing list - [email protected]
<mailto:[email protected]>
To subscribe, unsubscribe, or to change your mail settings:
http://lists.phxlinux.org/mailman/listinfo/plug-discuss
---------------------------------------------------
PLUG-discuss mailing list - [email protected]
To subscribe, unsubscribe, or to change your mail settings:
http://lists.phxlinux.org/mailman/listinfo/plug-discuss
---------------------------------------------------
PLUG-discuss mailing list - [email protected]
To subscribe, unsubscribe, or to change your mail settings:
http://lists.phxlinux.org/mailman/listinfo/plug-discuss
