I had the same problem. After some frustration, I discovered that putting pressure on that dual audio-style connector with my hand to hold in tightly in place throughout the entire download process solved the connectivity problem. Then again, I'm using a cheap Baofeng radio and Baofeng cable, so that might not be your problem. (Also, I'm running Debian, not Kubuntu.)
On Thu, Jun 22, 2023 at 8:47 PM Michael Butash via PLUG-discuss < [email protected]> wrote: > Looks like it's just creating a generic usb serial port, so I'd presume > you need to tell the program your hardware device serial speed, flow > control, bits, etc and have it misconfigured currently it's erroring in > that seeing bits it expects returned. Being legacy serial vs like a > hardware sdr, this is not negotiated but rather needs set for your device > requirements usually, but depending on your hardware that might not always > be the same. > > Also make sure the port is actually running on /dev/ttyUSB0 and not USB1 > or other, I've had this happen if a cable gets yanked or wiggled causing > the device to reset too quickly and is already in use. Check using "dmesg > | grep usbTTY" to make sure the number. > > -mb > > > On Thu, Jun 22, 2023 at 4:37 PM Jim via PLUG-discuss < > [email protected]> wrote: > >> I'm in need of help with Chirp on Kubuntu 22.04. CHIRP is a program >> that allows for easy programming of a transceiver and for backing up the >> configuration of the radio in question. I've used it before I upgraded >> to 22.04 and it worked. Now it doesn't. I have the port set to >> /dev/ttyUSB0. I give CHIRP the correct vendor and model information. >> Then I click download. Chirp shows nothing, but the radio says TX and a >> progress bar then Clone OK when it's done. This is what should happen. >> However Chirp should also show a progress bar. However it does >> nothing. Instead it give me a dialog box that says: >> >> Error communicating with the radio >> >> module 'collections' has to attribute 'Callable" >> >> This suggests to me that Chirp is sending data to the radio that tells >> it to send its data to Chirp, but it acts like the computer isn't able >> to receive it. Does anyone know how to fix this? >> >> >> Thanks. >> >> --------------------------------------------------- >> PLUG-discuss mailing list: [email protected] >> To subscribe, unsubscribe, or to change your mail settings: >> https://lists.phxlinux.org/mailman/listinfo/plug-discuss >> > --------------------------------------------------- > PLUG-discuss mailing list: [email protected] > To subscribe, unsubscribe, or to change your mail settings: > https://lists.phxlinux.org/mailman/listinfo/plug-discuss >
--------------------------------------------------- PLUG-discuss mailing list: [email protected] To subscribe, unsubscribe, or to change your mail settings: https://lists.phxlinux.org/mailman/listinfo/plug-discuss
