My computer setup needs two RS232 (serial) interfaces. I have the motherboard
one and I also have a separate PCI card (4348:3253). The separate card has been
going on the fritz since sometimes it just stops working. I bought another PCI
serial card and I thought I could swap them out. Unfortunately, the new card
(5372:6872) doesn't load the serial kernel driver like the old card. When I do
a lspci -v for the old card it says kernel driver=serial and for the new card
nothing is listed. I do an udevadm for both and the old one says serial and the
new one says serial8250. Not sure why it doesn't say serial8250 when I do a
lspci -v for the new card. Can you write a udev rule to load the correct
built-in driver? Also, I did a cat on the modules.builtin and it shows
serial_core.ko, 8250.ko, 8250_pnp.ko, 8250_pci.ko. I thought I would see a
serial.ko and serial8250.ko as well. Any suggestions or am I out of luck on the
serial card?
---------------------------------------------------
PLUG-discuss mailing list - [email protected]
To subscribe, unsubscribe, or to change your mail settings:
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
