Hi,
>hello. try turning off the pnp option of your e2000+ card. boot to dos, and lod
>up your NIC's setup program, assign a free irq and i/o value and tell this to
>your linux box in linuxconf->networking->client tasks->basic host
>information->adapter settings.
i have set the NIC to jumperless already with irq 10 and i/o address 0x280
doing netconf is the same right? i have tried setting the irq and i/o with 10
and 0x280 respectivly (configuration of the card)
but it did not work. I notice that when i execute the netconf command again, the value
for the irq and i/o is already gone. why?
How do i check if that irq and i/o is already used by other devices?
During boot up, when the initializing network card interface is always
failed...
>i don't quite trust linux's pnp yet, especially when it comes to NICs.
Ic..
>good luck.
>
no luck yet as of now... =(
Jackson
>
>Quoting Jackson Ching <[EMAIL PROTECTED]>:
>
>> Hi,
>>
>> I have installed RedHat 6.2, But it was not able to detect the
>> network> card (e2000plus) which is NE2000 compatible daw. how must i
>configure
>> my> linux so that it can detect the NIC and be able to use it? Thanks!
>>
>> Jack
>>
>>
>
>
>-------------------------------------------------
>This mail sent through IMP: mail.ateneo.net
>
>-
>Philippine Linux Users Group. Web site and archives at http://plug.linux.org.ph
>To leave: send "unsubscribe" in the body to [EMAIL PROTECTED]
-
Philippine Linux Users Group. Web site and archives at http://plug.linux.org.ph
To leave: send "unsubscribe" in the body to [EMAIL PROTECTED]
