On 09/20/2011 11:36 AM, Jason Barnett wrote:
> try adding a udev rule with the following lines in it:
>
> SUBSYSTEM=="usb", SYSFS{idVendor}=="*0bb4*", MODE="0666"
> SUBSYSTEM=="usb", ATTRS{idVendor}=="*0bb4*", MODE="0666"
>
> of course change the 0bb4 with the vendor ID of your device.
On 09/20/2011 11:41 AM, Paul Heinlein wrote:
> I *think* the snippet below
> would work, but you'll want to test it.
>
> # /etc/udev/rules.d/footpedal.rules
> KERNEL=="usb/hiddev[0-9]*", MODE="0644"
I tried Paul's idea first. It didn't work.
I tried Jason's next and they work. I didn't get the message about
restarting the service until after I had rebooted, so I'll have to try
that when I set this up on my laptop.
Thanks for all the advice.
Here's my rule file:
# /etc/udev/rules.d/footpedal.rules
#
# Set permissions for USB footpedal Infinity IN-USB-1
#
# sudo lsusb -v reports
# Bus 002 Device 002: ID 05f3:00ff PI Engineering, Inc.
# Device Descriptor:
# <...>
# idVendor 0x05f3 PI Engineering, Inc.
# idProduct 0x00ff
# bcdDevice 1.20
# iManufacturer 1 VEC
# iProduct 2 VEC USB Footpedal
#
# Rules recommended by PLUG mailing list member, Jason Barnett on
September 20, 2011
#
# After changing rules issue this command: sudo service udev restart
#
SUBSYSTEM=="usb", SYSFS{idVendor}=="*05f3*", MODE="0666"
SUBSYSTEM=="usb", ATTRS{idVendor}=="*05f3*", MODE="0666"
--
Regards,
Dick Steffens
_______________________________________________
PLUG mailing list
[email protected]
http://lists.pdxlinux.org/mailman/listinfo/plug
