hi,
try the following:
- use the graphical install
- when asked to create partitions, create both partitions (one in each
drive) with type 'linux raid'
- create two swap partitions as well, again, one in each drive
- set your raid device, normally /dev/md0, then add the corresponding
devices of both partitions (ex. /dev/hda1 and /dev/hdc1)
- proceed with the usual install procedure
take note that your system, as in a standard install, will work with only
one swap partition created, but i suggest you create one in each drive so
that if one drive fails, a valid swap partition will still exist in the
remaining drive.
willie
At 11:38 AM 10/02/2000 -0700, you wrote:
>Hello,
>
> I want to install RH6.2 into a computer with 2 Harddisk (15GB
> each) what i want to do is the 2nd HD will be a backup disk , so that
> would be hd2 will be a mirror to hd1. how do i do that? di ko
> maintindihan an docu. I'm goin to do it fresh install.
>
>Jackson
_
Philippine Linux Users Group. Web site and archives at http://plug.linux.org.ph
To leave: send "unsubscribe" in the body to [EMAIL PROTECTED]
