shouldn't put the same subnet ip addresses on different nics. I tried
 making eth0 into 192.168.10.1. Still doesn't work.

Still your using the same subnet in def NIC since your network is /16. use 
this ip again 192.168.10.1 then change all your netmask to 255.255.255.0, 
this will work. 

review your network assignment scheme.

On Wednesday 22 October 2003 10:36, Fritz Mesedilla wrote:
> Sorry I wasn't able to reply again. There seemed to be a problem with our
> email. It keeps on bouncing. I think we might be exceeding our bandwidth.
> :D
>
> Thank you to Al Maclang for replying. I was able to see your reply through
> the october archives.
>
> Anyway, here is our current setup:
> DEVICE=eth0
> IPADDR=192.168.8.233
> NETMASK=255.255.0.0
> BROADCAST=192.168.255.255
> BOOTPROTO=none
> NETWORK=192.168.0.0
> ONBOOT=yes
>
> DEVICE=eth1
> IPADDR=192.168.8.232
> NETMASK=255.255.0.0
> BROADCAST=192.168.255.255
> BOOTPROTO=none
> NETWORK=192.168.0.0
> ONBOOT=yes
>
> 192.168.8.233 - represents local lan no access to internet
> 192.168.8.232 - represents internt access
>
>
> ifconfig produces:
> eth0      Link encap:Ethernet  HWaddr 00:02:55:EE:C3:91
>           inet addr:192.168.8.233  Bcast:192.168.255.255  Mask:255.255.0.0
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:341396 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:6777 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:100
>           RX bytes:188778694 (180.0 Mb)  TX bytes:764553 (746.6 Kb)
>           Interrupt:10 Base address:0xa000
>
> eth1      Link encap:Ethernet  HWaddr 00:10:5A:D0:19:16
>           inet addr:192.168.8.232  Bcast:192.168.255.255  Mask:255.255.0.0
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:1769753 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:1428053 errors:0 dropped:0 overruns:0 carrier:1
>           collisions:0 txqueuelen:100
>           RX bytes:434467748 (414.3 Mb)  TX bytes:1172955565 (1118.6 Mb)
>           Interrupt:10 Base address:0xb800
>
> lo        Link encap:Local Loopback
>           inet addr:127.0.0.1  Mask:255.0.0.0
>           UP LOOPBACK RUNNING  MTU:16436  Metric:1
>           RX packets:38565 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:38565 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:0
>           RX bytes:5573561 (5.3 Mb)  TX bytes:5573561 (5.3 Mb)
>
> route produces:
> Kernel IP routing table
> Destination     Gateway         Genmask         Flags Metric Ref    Use
> Iface 192.168.0.0     *               255.255.0.0     U     0      0       
> 0 eth1 192.168.0.0     *               255.255.0.0     U     0      0      
>  0 eth1 127.0.0.0       *               255.0.0.0       U     0      0     
>   0 lo default         192.168.10.240  0.0.0.0         UG    0      0      
>  0 eth1
>
>
> When I try:
> - /etc/init.d/network stop
> - ifup eth0
>
> Nothing happens. Parang hindi naka-set yung eth0. Someone mentioned I
> shouldn't put the same subnet ip addresses on different nics. I tried
> making eth0 into 192.168.10.1. Still doesn't work.
>
> I just want local users to pass through eth0 and out eth1 for security
> reasons.
>
> Thanks.
>
>
> fritz <www.mesedilla.com>
> ---
> + Basta Ikaw Lord
>
>
> ----------------------------------------------------------------------
> This email and any files transmitted with it are confidential and
> intended solely for the use of the individual or entity to whom they
> are addressed. If you have received this email in error please notify
> the sender immediately by e-mail and delete this e-mail from your
> system. Please note that any views or opinions presented in this
> email are solely those of the author and do not necessarily represent
> those of the company. Finally, the recipient should check this email
> and any attachments for the presence of viruses. The company accepts
> no liability for any damage caused by any virus transmitted by this
> email.
>
> Overture Media, Inc.
> Direct Line: (632) 635-4785
> Trunkline:   (632) 631-8971 Local 146
> Fax: (632) 637-2206
> Level 1 Summit Media Offices, Robinsons Galleria EDSA Cor. Ortigas Ave.,
> Quezon City 1100

-- 
Alben Benavente Alteza 
Information Systems Security Administration
Information Systems Dept./ Philippine Airlines 

--
Philippine Linux Users' Group (PLUG) Mailing List
[EMAIL PROTECTED] (#PLUG @ irc.free.net.ph)
Official Website: http://plug.linux.org.ph
Searchable Archives: http://marc.free.net.ph
.
To leave, go to http://lists.q-linux.com/mailman/listinfo/plug
.
Are you a Linux newbie? To join the newbie list, go to
http://lists.q-linux.com/mailman/listinfo/ph-linux-newbie

Reply via email to