Folks, I was given an ADTRAN NetVanta 1234 PoE 24 port administered switch. One of the request of the donor was that I would remove any corporate configuration files. I proceeded to do so IAW instructions setout by Adtran.
The next step is to upload a config file that makes it factory reset (the next version of this had the factory reset file hard burned into the machine this one not so) Anyhow I have followed the instructions but still cannot get the device to recognize the file. Is anyone familiar with these devices? I figure that PLUG was the best place to ask this question short of calling the manufacturer and not sure how far I will get there since the thing is I guess about 10 years old. I am using minicom to talk to the console port, I invoke xmodem to upload the file to the flash drive on the switch, then in minicom I start xmodem it ask for the file location, I give it that and it sends it. Tells me that it was completed Then I reboot the switch, it starts rebooting then tells me that the file is no good. I am going to use this to carry several PoE'd access points and security cameras each system on a separate VLAN. It has 4GB throughput each port is 100mb so that is more than enough for the devices attached to it. But uploading the config file is giving me heartburn. Thank you in advance for any guidance given. -- Chuck Hast -- KP4DJT -- I can do all things through Christ which strengtheneth me. Ph 4:13 KJV Todo lo puedo en Cristo que me fortalece. Fil 4:13 RVR1960 _______________________________________________ PLUG mailing list [email protected] http://lists.pdxlinux.org/mailman/listinfo/plug
