PaulH wrote: > I hope I have made myself clearer. I should have started there! Much clearer.
I don't know about PCP and as you are doing development, I'd start with LMS on a full Raspbian/Max2play system to have full flexibility rather than cut down piCore. Once you have a workign system, then figure a way to get it goingon on PCP as you may need to do a custom build if an extension is not available. Simplest scenario: Enable serial console on pi (e.g. https://medium.com/@sarala.saraswati/connecting-to-your-raspberry-pi-console-via-the-serial-cable-44d7df95f03e ) Then using arduino - login into Pi (i.e.codes wait for "Login:" prompt, code replies with userid and then wait for "password:" prompt and replied with password. Once in run telnet command. If this is too complicated then a reverse telnet or maybe socat can connect serial port direct to LMS port 9090. You'd have to find out how to get the /dev/tty type driver running on GPIO pins to acts as serial port on the Pi for "reverse telnet" or socat to access (e.g. https://spellfoundry.com/2016/05/29/configuring-gpio-serial-port-raspbian-jessie-including-pi-3-4/) although probably much easier to buy a cheap USB-serial adaptor. ------------------------------------------------------------------------ bpa's Profile: http://forums.slimdevices.com/member.php?userid=1806 View this thread: http://forums.slimdevices.com/showthread.php?t=115760 _______________________________________________ plugins mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/plugins
