Paul Webster wrote: > How about controlling Squeezelite rather than Jivelite? > > https://forums.slimdevices.com/showthread.php?110640-Howto-create-a-linux-kernel-IR-remote-keytable-for-Jivelite-on-piCorePlayer-5&p=983475&viewfull=1#post983475
I had seen that post before, but the warning about it being "hard" stopped me. I just read more and it's not SO bad... hmmm... I think I'll give this a try soon. > > Otherwise ... if it has to be Jivelite then once you go through the > language set-up and connect to your LMS then you should find that > Jivelite remembers that for the future and no longer prompts for it > (might need to force a pCP backup for it to be retained over boot). ...and you've solved another mystery for me! I played with jivelite on one of my Pis that has a display, but when I rebooted it, jivelite re-ran setup. If I could just get it to save the config (probably with a pCP backup like you said), this whole thing might get a lot easier. I'll mess around with these options and see what I can do. However... I've been thinking about maybe using a touch screen on the two Pis I want to remote control. Touch screen should be kinda nice actually. Are there any relatively baked hardware devices that are not a bare screen? Meaning no exposed electronics and hopefully some kind of stand so the touchscreen would be usable sitting on a flat surface (like a table). If a device like that isn't too expensive that might be a better alternative for me. Thanks for all your suggestions. :) Brian. ------------------------------------------------------------------------ bgentry's Profile: http://forums.slimdevices.com/member.php?userid=69202 View this thread: http://forums.slimdevices.com/showthread.php?t=115816 _______________________________________________ plugins mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/plugins
