I suspect those codes could be shortened somewhat but I'm not an expert in sorting that out. It looks a little like the sequence is repeated five times in the on code that you provided.
If the receiver's own remote won't perform the on/off function then the IR Blaster is never going to be able to do it either as it sounds like the receiver has a fault. However, some remotes have different modes such as TV where the power and other controls switch to the TV control signals but volume, for example, stay with the receiver signals. It would be worth you checking for that and if that is the case relearning the working on/off signals. If the test buttons in the SC settings cause the correct action then three things come to mind. The first is interference between the SB remote and the IR Blaster signal. If the receiver is in line of sight for the SB remote then it is likely to be receiving both that and the IR Blaster signal simultaneously which is likely to confuse it. Try covering the IR Blaster attached to the receiver's IR Receiver with something opaque such as book or ensure it cannot see the SB signal. The second is repeat timing. The IR Blaster may be sending the repeat of the volume command too fast for the receiver which is confusing it. The third is repeat signal. Some remotes send a slightly different code for a single button press to a button that is held down so it may be that the receiver is ignoring the repeated volume control because it is not expecting to see the single shot volume control repeated so quickly. It may be worth asking the manufacturer if they will let you have to correct codes. -- Zaragon ------------------------------------------------------------------------ Zaragon's Profile: http://forums.slimdevices.com/member.php?userid=14577 View this thread: http://forums.slimdevices.com/showthread.php?t=46222 _______________________________________________ plugins mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/plugins
