Hi folks - I am new here so be gentle! I am pretty much a noob on matters linux - but have recently managed set up 3 raspberry P1 2 mini computers running a Max2Play based, 3 room streaming audio system working over WiFi network. Setup of all three players is identical. All running the latest Max2Play versions All was working fine initially.
However - I am having a strange issue with only ONE of the three players. (Apparently after an apt-get update/upgrade, but not absolutely certain that was the cause - I just noticed it then) One of them wont play low bitrate / sampling rate mp3s at the correct speed - low bitrate/sampling rate files are played too fast (I assume in the ratio of the sample rates) The other two players are fine. I have started again with a fresh Max2Play installation on the "broken" Pi, everything is working as before (getting excellent sound from IQaudIO PiDAC+) - BUT the same problem is happening with playback speeds. Now it gets really weird: I then swapped out the SD Card from the "broken" Pi with a card from a "working" Pi. The playback issue stayed with the physical HARDWARE - I didn't think that was possible - I assumed EVERYTHING was initialised after power down. Is there any way a Pi could retain information about audio / ALSA setup after power is removed and a new OS booted? Does this suggest I have a defective Pi or can anyone give me any ideas of how to proceed here. Thanks FG ------------------------------------------------------------------------ FeelGype's Profile: http://forums.slimdevices.com/member.php?userid=64566 View this thread: http://forums.slimdevices.com/showthread.php?t=103923 _______________________________________________ plugins mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/plugins
