Leonid Kapel wrote:
Jeff/Adam,
Thanks for your suggestions, but the problems still exist. The first
time I setup a new project, everything works fine. The problems start
whenever I make changes to the existing project.
Here's what I have noticed. Every time I visit the 'Persistence'
screen, the Client Variable Storage setting resets to ‘This
Datasource’, even though I tried setting it to both ‘Registry’, and
‘Cookie’. It does not keep the value I have selected in the past. In
the CFMX Administrator my default setting for client variable storage
is ‘Registry’.
That looks like a bug. I guess I never noticed it before, because I have
a tendency to manually edit the Environments.cfm after the initial
generation. I would try doing that to get things working instead of
using the Plum IDE until Adam checks this issue out.
For the second issue, I can’t change the URL to
‘http://localhost/PlumTutorials’, because Plum is installed on my
local PC, and Coldfusion and IIS are installed on a development
server. In any case, I don’t understand why I can’t use
‘http://fc-dev-01/PlumTutorials’, since it is a valid URL. I am using
a static IP, which is mapped to c:\inetpub\wwwroot.
Ok, I get it. fc-dev-01 is the name of the server. It should work then,
as you have it setup, unless there is validation going on in the field
and it doesn't like the hyphens. I encountered a problem like this in an
earlier beta, and I thought it was fixed. Can you try setting the values
manually in the Environment.cfm file manually to see if it will work?
Also, remember that these are application-scoped variables, and if you
change them you will still see errors until you recycle the CFMX server,
or comment out the "if (NOT IsDefined("Application.urlRoot")) { }
bracket in the directly underneath the <cfscript> tag at the top so that
the variables are overwritten each time.
HTH,
Jeff
Regards,
Leonid
-----Original Message-----
From: Jeff Fleitz [mailto:[EMAIL PROTECTED]
Sent: Tuesday, September 07, 2004 11:15 AM
To: [email protected]
Subject: Re: [plum] Generating forms for the InventoryItem table Tutorial
Hi Leonid,
The error below is being caused by line 28 in the bold. You are
specifying client management, but not a repository to put it in. The
clientStorage variable in line 28 normally defaults to "Registry". It
cannot be blank in your instance. Check your CFMX Administrator setting
for client variable storage, and see what the default is. Then adjust
the setting in the Environments.cfm file accordingly.
As far as the second issue, from looking at your configuration, I would
guess that the address would be http://localhost/PlumTutorials, unless
you are using a static IP address which is mapped to c:\inetpub\wwwroot.
Jeff
Leonid Kapel wrote:
Good morning Adam,
I ran into a problem following the instructions for the first four
steps of the “*Generating forms for the InventoryItem table*”
tutorial. I have chosen to overwrite all the files with the new
generated code. The screen shot of the error is attached.
I’m also getting an error on the ‘*Paths’* screen. I have checked the
URL, and it is correct. A screen shot is attached.
Thanks,
Leonid
//~~~~~~~~~~~~~~~~~~~~~//
Leonid Kapel
Rudolph and Sletten
Information Services
650-377-1804
[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]>
--
_______________________________
Jeff Fleitz
Tekquest, Ltd
Integrated Digital Solutions
http://www.tekquest.com
_______________________________
--
_______________________________
Jeff Fleitz
Tekquest, Ltd
Integrated Digital Solutions
http://www.tekquest.com
_______________________________
