Hi, Li, Aubrey píše v po 09. 08. 2010 v 09:09 +0800: > Milan Jurik wrote: > > > > Hi, > > > > during playing with new build 145 I discovered strange thing: > > > > C0 (cpu running) (100.0%) 1000 Mhz > > 100.0% > > C1 0.0ms (0.0%) 1333 Mhz > > 0.0% > > 1667 Mhz > > 0.0% > > > > Also kstat indicates that system is running on 1GHz only. No difference > > between poll-mode and default. > > Is powertop freezing? did you see the change of Top causes for wakeups?
This is interesting. I did not expect it because other commands were redrawing but I missed it. When I tried to reproduce it this morning, for the first time I saw different percentages than 100, 0, 0, and powertop stops to redraw the values (including top part). Also, in aprox. one from five cases I run kstat, I see current_clock_Hz going to the maximum value, for the rest of time it remains on 1GHz - no idea why because harddisk seems to be inactive and compilation is running. Also again it does not depend on poll-mode or default. > 100% C0 residency indicated the system has 100% cpu utilization. > Yes, I would expect it. > when you used poll-mode, did you set cpu-threshold to 1s in /etc/power.conf? Yes. > It would be interesting to see how the compilation caused 100% cpu > utilization. Do you know SFE repo? SFEboost.spec is my test case > I tried to do the nightly, everything works fine. Can you give more details > how > to replicate this issue? > What system did you use for replication of the issue? My system has some memory limits (ZFS, Gnome desktop, 4GB of RAM) and 2 cores and standard laptop harddisk (but that seems to be not active during build much, it goes to memory cache). > By the way, we didn't change cpupm related code for a long time, does this > issue > exist on the other build? > I saw it in build 145 the first time, but I did not use previous few builds for this type of workload. I can look at older builds if necessary. > Thanks, > -Aubrey > Best regards, Milan > > > > This combination happen when I run intensive compilations (build of > > boost with Sun Studio). And it is very strange even more, typical output > > of prstat: > > > > 9667 mj162486 66M 62M cpu0 30 0 0:00:06 13% ccfe/1 > > 9671 mj162486 60M 55M run 21 0 0:00:05 11% ccfe/1 > > > > but top reports: > > > > 9643 mj162486 1 31 0 63M 59M run 0:05 46.59% > > ccfe > > 9650 mj162486 1 22 0 48M 44M run 0:02 26.60% > > ccfe > > > > Basically I see much smaller values of CPU usage in prstat than in top. > > And I am pretty sure that in reality the CPU (Intel C2D in Thinkpad T60) > > is very busy (also Gnome applet shows full load). > > > > If I break compilation and do some "normal" work like browsing, powertop > > shows some changes in frequency to higher values. > > > > Best regards, > > > > Milan > > > > _______________________________________________ > > pm-discuss mailing list > > [email protected] > > http://mail.opensolaris.org/mailman/listinfo/pm-discuss _______________________________________________ pm-discuss mailing list [email protected] http://mail.opensolaris.org/mailman/listinfo/pm-discuss
