... or configure the sysctl.conf (in my opinion /etc/sysctl.conf):
net.ipv4.ip_nonlocal_bind = 1
and create an additional network-device like eth0:0 for the shared ip.
Greatings
Paul
schrieb Peter Shaw, Am 15.10.2013 12:38:
As i posted this, after a morning searching, i found this:
Linux-specific: some people use various redundant /Pound/ solutions for
Linux which require /Pound/ instances on separate machines to bind to
the same address. The default configuration of Linux does not allow a
program to bind() to non-local addresses, which may cause a problem.
Solution: add
echo 1 > /proc/sys/net/ipv4/ip_nonlocal_bind
maybe this will be my answer.
I'll give it a try.
sorry for polluting this list.
---
ps
B. unthoughted.wordpress.com <http://unthoughted.wordpress.com>
T. @peter_shaw
F. facebook.com/PeterDunstonShaw <http://facebook.com/PeterDunstonShaw>
G. github.com/petershaw <http://github.com/petershaw>
On Oct 15, 2013, at 12:13 PM, Peter Shaw <[email protected]
<mailto:[email protected]>> wrote:
Hi folks,
i googled and tested a few hours by now, but i defiantly need your
help again.
I have two pound servers in hot standby. One has IP .10, the oher has
IP .20. Both shares a virtual ip .30. If Server A get's down, than
Server B take over the shared IP.
I have a config file in sync on both servers.
Till our last failover test, i configured pound to listen on the
shared IP .30. That breaks our test, because pound on Server B was not
started, because the shared IP was not configured at start time.
Ok, we change the ListenHTTP address to 0.0.0.0. Pound starts up, and
the failover works perfectly.
Problem was solved. --- not really..
One of our scripts sends a header redirect to an external site. With
the .30 address this configuration works, but since we change the
address to 0.0.0.0 every redirect to an external site will be
overwritten to the domain url of the backend host.
my domain http://example.com/foo/bar sends a redirect to eg.
http://www.reddit.com/r/pics/
Pound is translating this redirect to http://example.com/r/pics.
I tried both ways: changing the IP back to .30 (can't find a solution
how to start pound to a address that is unconfigured) or disable the
domain rewrite while address is 0.0.0.0. Both fails.
Any ideas, how i can manage this?
Thanks a lot.
peter
---
ps
B. unthoughted.wordpress.com <http://unthoughted.wordpress.com>
T. @peter_shaw
F. facebook.com/PeterDunstonShaw <http://facebook.com/PeterDunstonShaw>
G. github.com/petershaw <http://github.com/petershaw>
--
To unsubscribe send an email with subject unsubscribe to
[email protected] <mailto:[email protected]>.
Please contact [email protected] <mailto:[email protected]> for questions.
--
To unsubscribe send an email with subject unsubscribe to [email protected].
Please contact [email protected] for questions.
