--- In [email protected], "brucexs" <[EMAIL PROTECTED]> wrote:
>
> >
> > Command List| properties | bars | Millisecond Mouse held
>
> >
> > I want to set this individually..
> >
> > Thanks for any suggestion or tip
>
>
> PowerPro only has one value for all bar shows and in fact it is
the
> same value as the one on keys|setup (time mouse held at edge).
>
> So if you want different timings for different bars, you need to
use a
> bump edge hot key programmed to run a script which creates a
single-
> signal event for each bar on that edge (there are also ways to do
it
> with one event for all bars on that edge). When the time elapses
for
> the event, check the mouse position, and it is it is still at the
> edge, show the bar. You also need to change the bar properties
show
> if bump to none.
>
Hi.. Bruce..
Thanks for Tip..
---------------------
local aa bb cc dd
aa = xmouse
bb = ymouse
WAIT.FOR(400)
cc = xmouse
dd = ymouse
if ( (aa == cc ) && (-50 <= bb - dd <= 50) ) do
bar.show("pp_help")
else
quit
endif
quit
----------------------
Best Regards..
kottami,
Attention: PowerPro's Web site has moved: http://www.ppro.org
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/power-pro/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
