>I went to www.lowendmac.com to search the archives for the Powerbook list.
>I don't see any links there for step-by-step on installing the card..

The archives are at www.mail-archive.com, see the sig on each post here for
the exact URL.  The next to last line of the sig :)  It was about 6 months
ago not 4, as I found when I searched for "Focus"

The link for the Focus instructions posted by  Bruce, is:
<http://www.mail-archive.com/powerbooks@;mail.maclaunch.com/msg02641.html>

And the full text follows, cut-n-pasted from 2 posts.

HTH.  Thanks Bruce.

Brian

-------------------------------------------
                        From: Bruce Johnson
                        Subject: Re: 5300 & Focus video/ethernet card
                        Date: Wed, 17 Apr 2002 14:24:11 -0700


              Malcolm Cornelius wrote:

              > I was going from memory, that'll be the heat sink.
              >
              > Flip the keyboard to the back, flip the trackpad and palm
rest forward, undo
              > the HD and flip sideways, lift the heat sink out and then ...

              total procedure:

              1)Remove three screws from the centerline of the mac underneath.

              2)Ease the keyboard up and away. Lean it against the screen.

              3)Carefully pull/tilt the front palmrest and trackpad up and
toward you
              a bit to disengage the catches in the front thencarefully
pull it up and
              lean it against the keyboard. Or you can do what I did:
struggle with it
              a bit, have it pop loose suddenly and come comletely loose.

              If this happens, verify that you didn't tear the trackpad
cable...:-(

              4)Undo the three silver screws holding the heatsink/harddrive
casing
              down. They are along the front of the PB.

              5) Carefully lift the HDD cage assembly and flip it over to
the left.
              You may want to carefully pull the HDD cable loose, just to
get some
              working room. It onbly goes one way, but be careful to handle
the
              connector only by the plastic edge, NOT the cable.

              6) Lift the power regulator board(?) up and to the right.
This has a
              white plastic cover on it, and it connects via a press in
connector
              towards the screen side under neath what you see. It is also
attached to
              the PRAM battery on the right hand side.

              7)Now lift the metal heatsink up and away.

              8)At last, you can see the video card. There is a screw
through the back
              of the PB (in the rear connector panel) and a screw on the
lower right
              hand side of the video card. It is, as Malcom said, obvious
at this
              point. That lower screw is screwed into a white nylon spacer
under neath
              the video card, so the screw will not come entirely loose.
With both
              wcrews out, carefully raise the near end to disconnect from
the MB and
              slide the video card straight toward you until it clears the
rather
              closely attached video cable across the top of it.

              9) Carefully slide the Focus card into the place, again being
careful of
              the video cable and push id on to connect.

--------------------------
              DOH! 9.5) Re-insert the screws holding the video card into
place, making
              sure to use the white nylon spacer.
              running the screw partway through the spacer will hold it in
place for
              this operation.
--------------------------

              10) Replace the heat sink.
              11) Replace the Power regulator
              12) Replace the HDD cage. Remember to plug it back in!
              13) Replace the trackpad/palm rest assembly. It is a bit
finicky getting
              it back together. Use more patience than force. Remember to
plug the
              cable back in!
              14) Put the keyboard back on, and reattach the screws in the
bottom of
              the back.

              All done. Just press the power key and...panic, because
nothing happens!

              Remember to press the little rest button on the back and it
starts up.

              Breathe huge sigh of relief.


--



-- 
PowerBooks is sponsored by <http://lowendmac.com/> and...

  Small Dog Electronics    http://www.smalldog.com   | Enter To Win A |
  -- Canon PowerShot Digital Cameras start at $299   |  Free iBook!   |

      Support Low End Mac <http://lowendmac.com/lists/support.html>

PowerBooks list info:   <http://lowendmac.com/lists/powerbooks.shtml>
  --> AOL users, remove "mailto:";
Send list messages to:  <mailto:powerbooks@;mail.maclaunch.com>
To unsubscribe, email:  <mailto:powerbooks-off@;mail.maclaunch.com>
For digest mode, email: <mailto:powerbooks-digest@;mail.maclaunch.com>
Subscription questions: <mailto:listmom@;lowendmac.com>
Archive: <http://www.mail-archive.com/powerbooks%40mail.maclaunch.com/>

Using a Mac? Free email & more at Applelinks! http://www.applelinks.com

Reply via email to