On 07/01/2011 03:42 PM, Jeff Johnson wrote: > I have a report that is not printing. Usually I open the tables and > run the report form in the command window and it will show an error. > Usually "Variable not found" or something like that. I have scoured > the frx looking for errors and I can't find any. When I run the > report from the command window nothing happens. It looks like it's > printing (status bar) but no output and no error. > > I don't believe I've seen this before. Any ideas? > > TIA > Thank you all that responded. The report was a FPW2.6 report and when you open it up in VFP9 it does a conversion. The report printed fine until I added a VFP9 control. Then the report would not print and gave no errors. I created a blank VFP9 report and copy and pasted all of the controls from the FPW2.6 report and it worked fine.
On the other reports I just copied and pasted the controls to a VFP9 report and they all work. Jeff --------------- Jeff Johnson [email protected] (623) 582-0323 www.san-dc.com _______________________________________________ Post Messages to: [email protected] Subscription Maintenance: http://leafe.com/mailman/listinfo/profox OT-free version of this list: http://leafe.com/mailman/listinfo/profoxtech Searchable Archive: http://leafe.com/archives/search/profox This message: http://leafe.com/archives/byMID/profox/[email protected] ** All postings, unless explicitly stated otherwise, are the opinions of the author, and do not constitute legal or medical advice. This statement is added to the messages for those lawyers who are too stupid to see the obvious.
