Gianni, Yes, I've seen that file before, I just threw that tidbit in the mix in case it helped us figure this problem out.
Thanks! Paul H. Tarver Tarver Program Consultants, Inc. Email: [email protected] -----Original Message----- From: ProfoxTech [mailto:[email protected]] On Behalf Of Gianni Turri Sent: Tuesday, June 20, 2017 10:59 AM To: [email protected] Subject: Re: Modify Project from Config.FPW Hi Paul, the file _command.prg will contains the commands history and VFP places it in the same folder as foxuser.dbf / fpt. Don't delete it and retry! Gianni On Tue, 20 Jun 2017 10:20:29 -0500, "Paul H. Tarver" <[email protected]> wrote: I tried the .prg route before, but I re-did it based on your recommendation just in case I did something wrong. Here's what I have set up now: start-vfp9x64.FPW file: ************************************************************* TMPFILES=c:\temp EDITWORK=c:\temp SORTWORK=c:\temp PROGWORK=c:\temp PATH = .\DATA; .\FORMS; .\GRAPHICS; .\LIBS; .\MENUS; .\PROGRAMS; .\REPORTS; T:\LIBRARY DEFAULT = "T:\ACTIVE\TPM \" RESOURCE = "T:\ ACTIVE\TPM \FOXUSER.DBF" COMMAND = do "T:\ ACTIVE\TPM \start-vfp9x64.prg" ************************************************************* start-vfp9x64.prg ************************************************************* CLEAR MEMORY CLOSE DATA CLEAR ALL CLOSE ALL SET SYSMENU TO DEFAULT CD " T:\ ACTIVE\TPM\" MODIFY PROJECT trnslate.pjx NOWAIT ACTIVATE WINDOW COMMAND ************************************************************* When I start VFP from the shortcut, the .FPW is processed and the .PRG is run, the project manager opens with the correct project, a blank command window opens and I cannot type in the command window because every keystroke is passed directly to the project manager. Once I close the blank command window, I can open a new command window and everything works normally. Same results that I get if I issue the MODIFY PROJECT command directly from the .FPW. Interestingly, if I open VFP in the folder and I type 'do start-vfp9x64.prg' in the command window, the project manager opens normally with the correct project info and goes immediately back to the regular command window ready for my next input. In other words, it looks like the problem may be in the .FPW file. So, I went back to the .FPW file and removed everything except the PATH and COMMAND lines. Same result. I also noticed that when I close the blank command window and file named _command.prg is created in the project folder. [excessive quoting removed by server] _______________________________________________ Post Messages to: [email protected] Subscription Maintenance: http://mail.leafe.com/mailman/listinfo/profox OT-free version of this list: http://mail.leafe.com/mailman/listinfo/profoxtech Searchable Archive: http://leafe.com/archives/search/profox This message: http://leafe.com/archives/byMID/profox/[email protected] ** All postings, unless explicitly stated otherwise, are the opinions of the author, and do not constitute legal or medical advice. This statement is added to the messages for those lawyers who are too stupid to see the obvious.
