Run the Project through the 'Documenting Wizard' Study the big ascii output file. Open it in the VFP editor (modi file ...) do a search.
Tedious, but thorough :D Or. Since most everything is a table anyway - you can iterate through the project file (as a table), open each thing (as a table) and look in the memo field(s) where the method code is stored, looking for 'RightClick' or something similar. Good Luck ! Regards [Bill] -- William Sanders / efGroup _______________________________________________ Post Messages to: [email protected] Subscription Maintenance: http://leafe.com/mailman/listinfo/profox OT-free version of this list: http://leafe.com/mailman/listinfo/profoxtech Searchable Archive: http://leafe.com/archives/search/profox This message: http://leafe.com/archives/byMID/profox/[EMAIL PROTECTED] ** All postings, unless explicitly stated otherwise, are the opinions of the author, and do not constitute legal or medical advice. This statement is added to the messages for those lawyers who are too stupid to see the obvious.
