Hi all:
Meant to post this a while back, but got caught up in something else and
then, when I realized I hadn't replied, I felt pretty stupid!
Anyhow, thanks to everyone who commented on my question about how to get
past the "Base table fields have been changed and no longer match view
fields" error. No matter what I did, short of recreating the report, the
view refused to "correct" itself, even after deleting it from the report
entirely.
I cannot explain why I could still open the view inside the project.
Probably one of those questions I'll never resolve. ;)
Anyhow, I chose instead to create a temporary cursor in the report
itself and to then relate it to a secondary support table that was required.
After a bit of twiddling, it all came out in the wash!
Thanks again for your help and suggestions. You all are the greatest!
Sincerely,
Jon
_______________________________________________
Post Messages to: [email protected]
Subscription Maintenance: http://leafe.com/mailman/listinfo/profox
OT-free version of this list: http://leafe.com/mailman/listinfo/profoxtech
Searchable Archive: http://leafe.com/archives/search/profox
This message:
http://leafe.com/archives/byMID/profox/B6A253D3986F4901BB353693CB583A78@Megabox
** All postings, unless explicitly stated otherwise, are the opinions of the
author, and do not constitute legal or medical advice. This statement is added
to the messages for those lawyers who are too stupid to see the obvious.
