Ulrich, I can duplicate the problem on macOS. The experience reported by Bob gives me good hints.
With luck we will have a fix later today. On Wed, May 16, 2018 at 1:23 PM, robert therriault <[email protected]> wrote: > HI Eric and Ulrich, > > I run a Mac and had successfully installed jd in the JHS environment and > so, seeing Ulrich's issue, I decided to try it in jqt and I could not > replicate what Ulrich has seen (in other words everything worked). I also > did the same for j806 and it worked there as well (after I had updated all > the addon packages). Just a point of reference really, but on my Mac with > j807 it works in JHS and jqt and for j806 it works on jqt. > > Hope this helps. > > Cheers, bob > > > On May 16, 2018, at 9:48 AM, Ulrich Vollert <[email protected]> wrote: > > > > Hello Eric, > > > > thank you very much for your help. > > > > I deleted addons/data/jd in my j64-806 folder. > > > > I am using a Mac and don’t use Pacman to install software. > > > > So, I started JQT, opened the Tools > Package Manager and installed JD, > version 4.4.60. > > > > Package Manager says > > > > Installing 1 package of size 280 KB > > Downloading data/jd... > > Installing data/jd... > > Done. > > > > And then load 'jd‘ gives the error message again > > > > !!! Jd key: non-commercial use only! > > !!! Jd key: invalid > > |assertion failure: assert > > | assert 0[echo invalidkey > > > > Could you give me a hint to narrow the error cause? > > > > Regards, > > Ulrich > > > > > > ---------------------------------------------------------------------- > > For information about J forums see http://www.jsoftware.com/forums.htm > > ---------------------------------------------------------------------- > For information about J forums see http://www.jsoftware.com/forums.htm > ---------------------------------------------------------------------- For information about J forums see http://www.jsoftware.com/forums.htm
