Thanks, Ric. I hadn't realized that you can send plots using PLOT to forms. I found the documentation on the plot WIKI.
Bob -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Sherlock, Ric Sent: March 11, 2008 6:07 PM To: Programming forum Subject: RE: [Jprogramming] Forms and Plots again ---Robert O'Boyle wrote: > I noticed that when I manually enter the set bparm in the > GRAPH script, that > it disappears from the script when I close the Design window. > What am I > doing wrong? I think that you'd be better setting these as part of graph_setup. That is take the set aparm & bparm lines out of GRAPH and add the following to graph_setup. wd 'set aparm 100 150 200 5' wd 'set bparm 100 150 200 5' > I thought that the pas command put a border around the isigraph but it > doesn't seem to. Can I add one? I would ultimately like to > add axis tick > marks but I don't know if this is possible. > > Finally, is there any way to change the 0, 0 origin to be at > the bottom left > rather than top left? Have you thought about using plot rather drawing the lines "manually"? You might want to check out the following scripts on the wiki for some ideas. http://www.jsoftware.com/jwiki/Scripts/QuadExplorer http://www.jsoftware.com/jwiki/Scripts/Real-time_Plot ---------------------------------------------------------------------- For information about J forums see http://www.jsoftware.com/forums.htm ---------------------------------------------------------------------- For information about J forums see http://www.jsoftware.com/forums.htm
