Hello, Thank you for your reply!
This panel tab showed up when I ran demo_VEH_HMMWV.py or any other Pychrono demo codes and hit the button "I". However, it didn't show up when I ran my own code, which was modified from demo_VEH_HMMWV_circle.py, even if I hit the button "I". So I'm trying to figure out where are the lines of codes in demo_VEH_HMMWV.py that enable the tab popping up by pressing "I" so that this panel tab also shows up in my own code. Best regards, Urara On Saturday, November 4, 2023 at 10:27:08 PM UTC-4 [email protected] wrote: > Hello, > Which lines you want to add to your code? And I am not sure which > functionality you want to achieve here, as you said, I thought this panel > tab already showed up right? > > On Friday, November 3, 2023 at 11:11:07 AM UTC-5 [email protected] > wrote: > >> Hello, >> >> I'm using Pychrono and want to show the info tab as seen in the >> screenshot attached to this email. >> When I run demo_VEH_HMMWV.py, this tab pops up when I hit the "I" button >> during the simulation. >> However, this tab does not show up in my code even if I hit the button. >> >> Where is this tab implemented or enabled in pychrono? >> I want to add those lines of codes to my code. >> > -- You received this message because you are subscribed to the Google Groups "ProjectChrono" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/projectchrono/85033a90-7e5a-4b66-a15a-6f581ac6fb43n%40googlegroups.com.
