Micky Blain wrote:
> 
> 1. just go bit on a big order with power plane clearance. It seems that the
> gerbers generates the plane all the way to the edge of the keep out layers.
> Is there anyway to control the power plane and manually draw them in without
> doing them by split planes?

Just draw a wide track around the edge of the board on the plane layers.

Anything you draw on the plane layers ends up as "no copper" on the
finished board.



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
*  This message sent by: PROTEL EDA USERS MAILING LIST
*
*  Use the "reply" command in your email program to
*  respond to this message.
*
*  To unsubscribe from this mailing list use the form at
*  the Association web site. You will need to give the same
*  email address you originally used to subscribe (do not
*  give an alias unless it was used to subscribe).
*
*  Visit http://www.techservinc.com/protelusers/subscrib.html
*  to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

________________________________________________________

To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'

More Information : http://www.dolist.net

Reply via email to