If you go into Tools-->Preferences and then to the Default Primitives tab
you will find listings for each of the part fields.

Unhide the fields you wish to show.

Since I don't think this default primitive can be changed by placement...
becuase of how they are... I don't think you need to worry about the
Permanent box... this setting should remain permanent until you enter the
defaults to change it again since you cannot change this during placement.

----------------------------------------------------------------------
Colby Siemer                        ** Custom Battery Chargers
                                           ** Custom Power Supplies
PowerStream Technology       ** Custom UPS
140 S. Mountainway Drive      ** Custom DC/DC Converters
Orem Utah 84058                  ** Power management electronics for OEMs

http://www.PowerStream.com


----- Original Message -----
From: Drew Lundsten <[EMAIL PROTECTED]>
To: Multiple recipients of list proteledausers
<[EMAIL PROTECTED]>
Sent: Friday, February 16, 2001 11:34 AM
Subject: [PROTEL EDA USERS]: Unhide part fields by default?


> Is there a way (a .ini or other setting) to have e.g. Part Field 1
> always be shown/not hidden? We use these fields for internal part
> numbers, stuffing options and some other information and it would be
> nice if Protel could show them by default rather than doing the
> uncheck-hidden-fields, unhide-part-field, recheck-hidden-fields mouse
> dance for each and every part.
>
> Thanks in advance,
>
> Drew
>
> --
> Drew Lundsten    <[EMAIL PROTECTED]>             direct  +1.858.882.8828
> Continuous Computing Corporation                fax  +1.858.777.3388
> 9380 Carroll Park Dr, San Diego 92121          cell  +1.619.847.4251
>
>
>
> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
> *  This message sent by: PROTEL EDA USERS MAILING LIST
> *
> *  Use the "reply" command in your email program to
> *  respond to this message.
> *
> *  To unsubscribe from this mailing list use the form at
> *  the Association web site. You will need to give the same
> *  email address you originally used to subscribe (do not
> *  give an alias unless it was used to subscribe).
> *
> *  Visit http://www.techservinc.com/protelusers/subscrib.html
> *  to unsubscribe or to subscribe a new email address.
> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
>



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
*  This message sent by: PROTEL EDA USERS MAILING LIST
*
*  Use the "reply" command in your email program to
*  respond to this message.
*
*  To unsubscribe from this mailing list use the form at
*  the Association web site. You will need to give the same
*  email address you originally used to subscribe (do not
*  give an alias unless it was used to subscribe).
*
*  Visit http://www.techservinc.com/protelusers/subscrib.html
*  to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

________________________________________________________

To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'

More Information : http://www.dolist.net

Reply via email to