I too have been wary of the synchronizer
the method you describe is what we use, it seems to work fine and is not
very hard

Dennis Saputelli

Greg Olson wrote:
> 
> It does seem to be light today, but I did see your post, so something is
> working!
> 
> I have a sort of procedural question I'd like to throw out to the group. I
> have been using Protel 99 for a couple of years now both for schematic entry
> and the subsequent PCB creation. I have always created netlist from the SCH
> and then gone into the PCB (which I manually place) and load nets. I also
> use this procedure if I make a change later in the SCH. I know about the
> synchronize SCH and PCB function but have been wary of it, the one time I
> tried it, it seemed to have a mind of its own. Is the way I'm doing it
> totally inefficient or is this a common practice?
> 
> Thanks,
> 
> Greg Olson
> DSX Access Systems, Inc.
> 
> ----- Original Message -----
> From: "Coleman, Tim" <[EMAIL PROTECTED]>
> To: "Multiple recipients of list proteledausers"
> <[EMAIL PROTECTED]>
> Sent: Thursday, February 15, 2001 11:09 AM
> Subject: [PROTEL EDA USERS]: Anyone there?
> 
> > ??
> >
> > Just checking, I've seen only a few posts from the forum today and that
> was
> > this morning.
> >
> >
> > Time is 5:09PM GMT
> >
> >

-- 
___________________________________________________________________________
www.integratedcontrolsinc.com            Integrated Controls, Inc.    
   tel: 415-647-0480                        2851 21st Street          
      fax: 415-647-3003                        San Francisco, CA 94110



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
*  This message sent by: PROTEL EDA USERS MAILING LIST
*
*  Use the "reply" command in your email program to
*  respond to this message.
*
*  To unsubscribe from this mailing list use the form at
*  the Association web site. You will need to give the same
*  email address you originally used to subscribe (do not
*  give an alias unless it was used to subscribe).
*
*  Visit http://www.techservinc.com/protelusers/subscrib.html
*  to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

________________________________________________________

To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'

More Information : http://www.dolist.net

Reply via email to