"Jackson, Ken" wrote:

> Is there anyway to display the workspace below the absolute origin.

No.

> when I produce the gerber
> files and load them into CAMtastic, there is some text and copper that shows
> up 3 inches from the bottom of the board.

But there is a way to deal with that.

Zoom out to the maximum level.  Then choose "Edit->Select->OutsideArea" and draw
a rectangle around the whole board.  This will select whatever is sitting off
the page.  Then you can drag the selection onto the active area and deal with it
as appropriate.

This will not work if the text is part of a string.  In that case, you can edit
the component and specify the coordinates for the string.

Hamid


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to