On Tue, 3 Apr 2001 08:12:25 -0700 , you wrote:

>I am doing a flex circuit in Protel. Flex requires the use of arcs in or
>radius corners, have any of you found a slick way to do this in protel that
>comes out clean? Any other time saving tips for flex design in protel?

I did a ribbon cable like flex that turned through 90 degrees. Manually
routing placing arc segments worked ok.

There was some issue about placing zero length arc segments which due to
display problems are invisible, perhaps that has been fixed. 

Also check with the manufacturer what they actually need from you - the
process may not be quite the same as conventional PCBs. 

Cheers, Terry.


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to