Hello,

I think this is the solution to your problem:
1) place the pad
2) double click on the pad
3) check the Past Mask Override checkbox
4) enter value higher than half the pads x- and/or y-size
5) click ok
If I'm not correct please somebody else could advice us since I'm foolling
my way around
with 99SE for the very first week. Did the upgrade dance from PCB 2.5 to
99SE sp6.
(A small step for Ben, but a giant leap for me as a designer...)
A nice weekend to all of you!



Ben Uytenhaak
[EMAIL PROTECTED]

Gatsometer BV
P.O. Box 4959
2003EZ  Haarlem
The Netherlands
-----Original Message-----
From: [EMAIL PROTECTED] <[EMAIL PROTECTED]>
To: [EMAIL PROTECTED] <[EMAIL PROTECTED]>
Date: vrijdag 6 april 2001 16:54
Subject: [PEDA] Solder Paste


>I've got a question for the group.
>
>I need to place thieving pads on some bottom side pads.
>
>My question is how do I remove the solder paste from these pads?
>
>Thanks.
>
>


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to