At 02:43 PM 4/5/01 +1000, Thomas wrote:
>Is it possible to assign multiple nets to a bus where the individual nets
>are not consecutively numbered.
>
>i.e. for a bus of nets D0 to D7 I can use D[0..7]
>
>but what about a bus of nets FA, FB, FC, FD etc...?

No, I think that is not possible. You can make a pseudo-bus, because it is 
the net labels that count, but if you want to go off-sheet, you will have 
to use either nets global or make a port for each net. I don't think I've 
seen a CAD program that would do an alphabetical sequenced bus.

Solution: use numbers if you can. What's wrong with F1, F2, F3.... or F10, 
F11, F12, F13.... if that's the point?

[EMAIL PROTECTED]
Abdulrahman Lomax
P.O. Box 690
El Verano, CA 95433


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to