Frank,
the only time that I see a particular query for a target board is
when there is more then one board in the database. Not to say that there
isn't a selection point in one of the windows along the path, I haven't
noticed.
Sincerely,
Brad Velander
Lead PCB Design
Norsat International Inc.
#100 - 4401 Still Creek Dr.,
Burnaby, B.C., Canada.
V5C6G9.
voice: (604) 292-9089 (direct line)
fax: (604) 292-9010
email: [EMAIL PROTECTED]
www: www.norsat.com
> -----Original Message-----
> From: Frank Gilley [mailto:[EMAIL PROTECTED]]
> Sent: Friday, April 06, 2001 8:42 AM
> To: Protel EDA Forum
> Subject: Re: [PEDA] Update PCB from SCH bug?
>
>
>
>
> At 09:29 PM 4/5/2001 -0700, Abdulrahman Lomax wrote:
>
> >I'm fairly new with the synchronizer; I thought I remembered
> a place where
> >you can set the target PCB, but I could not find it. I think
> it is only
> >set once; if it has been set previously, it remains at that
> setting and
> >the only way, apparently, to change it is to get the current
> PCB out of
> >the way. As I recall, if there is more than one possible
> PCB, one will be
> >prompted to choose which one is intended.
>
> Not its usual behavior.
> You are presented with the PCB target selection box each and
> every time,
> even when there is only one possible target in that folder.
> Interesting
> that it did not present itself to you. Did you do the Create
> New Board first?
> After the Create New Board cycle, any subsequent Update PCB
> acts as though
> you selected the new board and hit apply.
>
> Anyone else able to reproduce this? I was just wondering if it was
> specific to my installation or if it's a global bug.
>
> -Frank
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *