On 04:00 PM 6/04/2001 +0200, Ben Uytenhaak said:
>Hello,
>
>I think this is the solution to your problem:
>1) place the pad
>2) double click on the pad
>3) check the Past Mask Override checkbox
>4) enter value higher than half the pads x- and/or y-size
>5) click ok
>If I'm not correct please somebody else could advice us since I'm foolling
>my way around
>with 99SE for the very first week. Did the upgrade dance from PCB 2.5 to
>99SE sp6.
>(A small step for Ben, but a giant leap for me as a designer...)
>A nice weekend to all of you!
>
>
>
>Ben Uytenhaak
>[EMAIL PROTECTED]

Ben - you are spot on except in point 4) it should be a *negative* number 
higher than half the ....

A negative number means make the expansion smaller.

Ian


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to