Ian,

You're right about this and I know but I was in a hurry to formulate the
answer because there was someone waiting next to me to close the office.
Sorry if I caused any inconveniance.

regards,

Ben Uytenhaak
[EMAIL PROTECTED]

Gatsometer BV
P.O. Box 4959
2003EZ  Haarlem
The Netherlands
-----Original Message-----
From: Ian Wilson <[EMAIL PROTECTED]>
To: Protel EDA Forum <[EMAIL PROTECTED]>
Date: zaterdag 7 april 2001 03:13
Subject: Re: [PEDA] Solder Paste


>On 04:00 PM 6/04/2001 +0200, Ben Uytenhaak said:
>>Hello,
>>
>>I think this is the solution to your problem:
>>1) place the pad
>>2) double click on the pad
>>3) check the Past Mask Override checkbox
>>4) enter value higher than half the pads x- and/or y-size
>>5) click ok
>>If I'm not correct please somebody else could advice us since I'm foolling
>>my way around
>>with 99SE for the very first week. Did the upgrade dance from PCB 2.5 to
>>99SE sp6.
>>(A small step for Ben, but a giant leap for me as a designer...)
>>A nice weekend to all of you!
>>
>>
>>
>>Ben Uytenhaak
>>[EMAIL PROTECTED]
>
>Ben - you are spot on except in point 4) it should be a *negative* number
>higher than half the ....
>
>A negative number means make the expansion smaller.
>
>Ian
>
>


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to