Make a new part which has three terminals with two resistors.  Sort of a small 
resistor network.

Heart
Heart Transverter S.A.



Afshin Salehi wrote:

> Hello,
>
>     I am trying to place two resistors on a board such that they are end-to-end and 
>they share one common hole.  So you end up with 3 holes and either a resistor can be 
>placed in one side or the other to select different voltage levels.  When I try to 
>route the board it will not route the overlapping pads.  I am trying to figure out 
>how I can make Protel alright with this and I was wondering if anyone has done this 
>before.
>
>     Thanks for your time,
>
>         Afshin Salehi
>
>         DPS Telecom

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to