Hello,
   Has anyone figured out a work around so test points will only be exposed
on 
the tested side and tented on the untested side (like under fine pitch SMT
components)?
   Editing the Gerber's is the only way I know to do this now.  :(
I would prefer something that be reproducible after revisions are made.
   Any news about a new version coming?

Sincerely,
Carl Schattke, C.I.D.
Intel Corporation,  ACT 
Sr. Hardware Engineer ( PCB Design)
122 Saratoga Ave. Suite 100
Santa Clara, CA 95052
Office 408-556-3122
Fax 408-261-5869
24 Hr. Ph. 888-204-3704
Email:  [EMAIL PROTECTED]



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to