Power dissipation is the main reason why i still use 1206 package surface
mount. Though they are becoming increasingly difficult to source.

Rich

> -----Original Message-----
> From: Mark Richards [SMTP:[EMAIL PROTECTED]]
> Sent: 31 July 2001 20:21
> To:   Protel EDA Forum
> Subject:      Re: [PEDA] Surface Mount Boards
> 
> Norb,
> By the way, when I suggested 0805 footprints, I was not taking in to
> consideration voltage or power requirements. Be sure that ANY component
> and footprint is acceptable for the voltage and power before designing
> it in to your PCB.
> 
> Regards,
> 
> --
> Mark Richards
> ON Semiconductor
> 5005 E. McDowell Road
> Phoenix, Arizona 85008
> Phone: 602.244.7267
> Pager: 866-208-9913
> 
> 
> "Back, Norb" wrote:
> 
> > Hi All
> > Today is the fist time for a surface mount board.
> > Which is the most common footprint used for resisters
> > 603,805,1206 ?
> > The chip I am using uses a SOIC-8 footprint
> 
> 
> 
> 

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to