Carl,
        a word of warning. Read the CE requirements for labeling
requirements quite carefully, I don't remember the exact details but your
desired size appears to be well below their minimum size requirements if
this is the only CE mark to be applied to your product. The pertinent
details used to be found in the same section as the grid CE logo graphic.
        FCC has similar requirements but they 'were' not stated in their
actual regulations, however we had one product rejected years ago because
the size of the FCC ID were smaller then acceptable according to the
engineer handling our submission. Seemed to have been arbitrary according to
what we could determine at the time.
        I haven't had to deal with this for a fair period of time at the PCB
level so possibly there have been some changes in recent years.

Brad Velander,
Lead PCB Designer,
Norsat International Inc.,
#300 - 4401 Still Creek Dr.,
Burnaby, B.C., V5C 6G9.
Tel. (604) 292-9089 direct
Fax (604) 292-9010
website www.norsat.com


> -----Original Message-----
> From: Schattke, Carl [mailto:[EMAIL PROTECTED]]
> Sent: Tuesday, August 07, 2001 12:27 PM
> To: Protel EDA Forum
> Subject: [PEDA] Logo's for FCC, UL and CE ?
> 
> 
> 
> Hello,
>   I have  dense board to apply logos for FCC, UL and CE onto the silk
> screen.
> Ideal height would be ~.100 height, but anything would be great.
> Does anyone have these logos in a format Protel99SE can import?
> I would be grateful if you could share them with me.
> 
> Sincerely,
> Carl Schattke, C.I.D.
> Intel Corporation,  ACT 
> Sr. Hardware Engineer ( PCB Design)
> 122 Saratoga Ave. Suite 100
> Santa Clara, CA 95052
> Office 408-556-3122
> Fax 408-261-5869
> 24 Hr. Ph. 888-204-3704
> Email:  [EMAIL PROTECTED]

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to