Hi all,
        this is just to find out if anybody else has experienced the
following aberrations. And do you have any way of recovering better then I
did.

P99SE Schematic.
System font changes: I swear that I did not touch the system font button, at
least until I went to see what font it was set to. To my surprise it was set
to Times New Roman Regular 10, same as always. Shut down Protel, restarted,
system came back up with system font the same as normal.

P99SE Schematic.
        Editing a schematic, everything is fine. Suddenly I want to move
some selected items, press "M", "S", no cursor change from arrow to
crosshair, can't select the items to move. Go to start over, press "X", "A",
nothing happens previously selected parts are still selected. I get a slight
flicker of the main screen, like there was a very fast appearance of the
command menus. Several other commands are also not functioning. Shut down
Protel, restarted, system came back up with everything working normal. A day
and a half later I have not seen the same problem again (in the past I have
seen this several times and just want to avoid the slow shutdown, restart
routine).

Brad Velander,
Lead PCB Designer,
Norsat International Inc.,
#300 - 4401 Still Creek Dr.,
Burnaby, B.C., V5C 6G9.
Tel. (604) 292-9089 direct
Fax (604) 292-9010
website www.norsat.com

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to