No cant find any. But if its a multilayer but not plated?. How can i find
this?? Okej I know the hard way, click on every pad and check propertys.
This will take hours.

Tommy




-----Ursprungligt meddelande-----
Från: Bob Fearon [mailto:[EMAIL PROTECTED]]
Skickat: den 13 augusti 2001 18:02
Till: Protel EDA Forum
Ämne: Re: [PEDA] SV: Unplated SMD-pads??


They should show up on the screen as a different color ( multilayer
color) instead of top layer or bottom layer.


Tommy  kesson wrote:

> Okej, perhaps... But how do I find them?
>
> Tommy
>
> -----Ursprungligt meddelande-----
> Fr n: Bob Fearon [mailto:[EMAIL PROTECTED]]
> Skickat: den 13 augusti 2001 15:55
> Till: Protel EDA Forum
>  mne: Re: [PEDA] Unplated SMD-pads??
>
> Tommy
>     Do you have any of your SMD pads set as multilayer?
>     I have only seen this message when I made that mistake.
> Bob
>
> Tommy  kesson wrote:
>
> > Sometime then I do DRC I get an error message.
> > "Broken-nets contraint"
> > Net GND
> > Warning nets constain unpladet pads.
> >
> > How do I find this unplated pads!!!
> > Wy must SMD-pads bee plated!!!
> >
> > Any comments or suggestions??
> >
> > Regards
> > Tommy

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to