Yes,
I find that to be true also, someone helping me learn the program just used
* (Shift 8)
to place vias, I could never get this to work only the numeric keypad *
Bob
Robert M. Wolfe, C.I.D.
47 Chatfield Drive
Trumbull, CT 06611
203-261-2182
[EMAIL PROTECTED]
----- Original Message -----
From: "Michael Beavis" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Sent: Monday, September 10, 2001 11:43 PM
Subject: Re: [PEDA] 99SE manual routing problem


> G'day all.
> Just a bit of extra info,
> the * key for toggling layers will only place a via while you are actually
> routing a trace otherwise it just changes layers and only the key on the
> numeric keypad seems to work in this capacity on this machine ( not the
> shift 8 key ).
>
> regards,
>
> Michael Beavis
>
> Advanced Mining Technologies Pty Ltd
> Research & Development dept
> PO Box 5107, Chittaway Bay, NSW, 2261, (Australia)
> (3 Co-Wyn Close, Fountaindale, NSW, 2258)
> Tel: (+61) 2 4389 2344
> Fax: (+61) 2 4389 2355
> Email:  [EMAIL PROTECTED]
> Website:  www.advminingtech.com.au
>
>
>
>
> Hello Ivan,
> Just hit the '*' key and then one left click to place the via.
>
> regards,
>
> Phil
>
>
>
>
> Hello, all:
>
> When manually routing, the shortcut key '/' does not work.  Therefore, I
> cannot place a via connecting to an internal plane.  Yes, I do have the
> layer stackup with GND and VCC planes defined.  What gives?
>
> Best regards,
> Ivan Baggett
>
>

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to